Pool Pumps in Lighthouse Point, FL
Florida Pool Resurfacing is ready to address your Lighthouse Point Pool Pumps needs
Every mechanical equipment always needs repair and maintenance after a certain time. The same formula applies for your pool pumps or spa’s shell, the mechanical equipment that keeps everything on-going efficiently will give you benefit after regular maintenance. Most of these maintenance works are slightly complicated, but if you ask for our pool services Lighthouse Point regularly and the problems of your pool equipment are being address in time and your swimming pool will be able to give you best pleasure.
Maintenance of Pool Pumps – Lighthouse Point, FL
The pump for a pool or spa is the basic element to keep your pool clean every day and if it maintains on a regular basis then it requires very little maintenance. The duty of a pump in any swimming pool is to self-priming, so our professional pool services clean it regularly and clean out the strainer basket inside.
While checking the basket of pool pumps, we thoroughly inspect the condition of the O-ring or gasket that seals the lid of the pump housing. If it is leaked or has deteriorated, we always have all spares to replace it otherwise; the lid will not be able to form the seal that’s required to keep the pump in operation. The water leak from your pump is not an ordinary issue for your swimming pool and must be fixed through our professional services.
When to Replace Your Pool Pumps – Lighthouse Point, FL
As already described, the pump of a swimming pool is a vital piece of equipment that needs to keep your pool water clean, warm and hygienic. Once the pool pump crashed or worst, it burns out. We provide the latest and best alternative solutions that could be done.
New generation technology in swimming pool pumps comes out in the market and we are fully trained and equipped with automatic controls, safety features. We provide various solutions that help to multiply the performance of your pool pump.
Many a times there are some complicated problems and troubles that only our experts could be handling on these matters, especially on the electrical aspects.
Commonly it is assumed that a Pool Pump Motors life is about 8-10 years. To avoid these common mistakes that pool owners often do when troubleshooting their pump, here are few of the usual pump problems:
Problem in Bearings
Defective bearing is the most common trouble pool pumps always bear. Weak bearings cause shock, vibration, and damage. Once the sounds of the pool pump experience some irregularity, it’s time to replace the bearings.
Our professional team will visit you and replace both bearings (rear and front). Bearings are the most sensitive parts of your poop pump as these are the ones that are subject to more stress than any other part of the pump system.
Problem in Impeller
Impellers are also very sensitive for blockage, particularly when the water is pumping full of debris that may pass through the strainer or filter. Sometimes, the impeller washer, nuts and bolts have loosened and these blocked the whole system.
Dry Pool Pumps
Swimming pool pump motor should be run with sufficient water on its suction side. Few models of pumps are self-priming while some are primed manually. If mistakenly the pump of pool is run without water on the system, this may be the reason for motor over speeding and it has no medium that may slow the speed down. In such a case, the motor should be shut-off directly to avoid further damage to the system.